Bungard RDC 30, Translation Of The Original Instructions, Page: 10 / 13

rdc-30-manual-en Page 10 /
Screen # Description Display
28 Then it will begin the descend. The display for distance drive
and dip drive is the same, but you will notice that a different
speed will be displayed. If you have set e.g 3 iterations for this
vessel, the display starts with iteration 3. The same is valid for
iterations of the whole sequence (Iteration g)
29 If you adjusted a dipping time, the screen on the right shows up
and counts down the time. If you haven't adjusted a time, the
screen will just flash...
30 ... and the machine continues with the drive up to the end or to
the virtual end position. Again the display for distance drive and
dip drive is the same, but you will notice that a different speed is
displayed. If you have set e.g 3 iterations for this vessel, the dis-
play starts with iteration 3. The same is valid for iterations of the
whole sequence (Iteration g). After having completed the vessel
for this sequence.....
31 ..... the machine drives to the next table position...
32 If you adjusted a drip off time the screen on the right shows up
and counts down the time. If you haven't adjusted a time, the
screen will just flash...
33 ....... and continues with the next descend. The screens 28 till
32 will continue till the whole job is finished.
34 At the end of the job the lever arm will rest at the virtual end po-
sition and the table will turn to home position.
35 You are asked to confirm with 1 and then screen 12 (main
menu) shows up again.
Selected parameters are stored and can be used next time the machine is switched on.
Limit switches prevent drives that exceed the maximum possible way.
Please take great care when adjusting stroke length and speeds. Consider the height of the
liquid container and additional stirring devices.
We do not warrant damages caused by wrong settings.
Drive down
Iteration 1
Speed down: 5200
Iteration g.: 2
wait
stir on
Timer 00:00:00
Drive to
table position
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/9 28 28 - 0, Fax: +49 (0) 2292/9 28 28 - 29, E-mail: support@bungard.de
Drive down
Iteration 1
Speed down: 950
Iteration g.: 2
Drive up
Iteration 1
Speed up: 950
Iteration g.: 2
Drive up
Iteration 1
Speed up: 4000
Iteration g.: 2
Drive down
Iteration 1
Speed down: 5200
Iteration g.: 2
wait
stir on
Timer 00:00:00
Iteration g: 2
Drive to
Table home position
Job completed
Ok press 1