Bumper Boy Ultra II, Operation And Maintenance, Page: 5 / 22

BB Trainer Revision 3.doc
6
3
Duck
1 2
3
4
3
Human
1
Duck
2
Pheasant
4
Goose
The transmitter communicates with the launchers
programmed for operation under its control by a radio
frequency link. It uses one of over 17,000 frequency and
digital code combinations to virtually eliminate interference
from other transmitters. The frequency and code
combination is synchronized with the receiver on the
launcher during the programming steps. The keys are
arranged in three columns for convenience during
operation. The left column controls the sound programmed
for the launcher designated by the number on the key. The
middle column controls motion for the designated
launcher, if the motion module is installed. The right
column controls launch for designated launcher number.
The printed words on the launcher keys designate to the
functions controlled during programming.
The transmitter programs and
controls up to four launchers. They
are designated I through 4 on the
keys in the LAUNCH column. These
keys are used to launch
SmartBumpers or Super-birds from
the launcher designated on the key.
They are used to select the
launcher number during programming.
During operation, the SOUND
column turns on the sound
programmed into the launcher
corresponding to the launcher
number on the SOUND key.
During programming, the
SOUND column selects the
sound to be programmed into
the selected launcher. That
sound is noted on each key. For units with standard sound
(chirping) no other sounds can be programmed.
BB Trainer Revision 3.doc
7
Red light “ OFF ” safety
“
ON
”
Armed (caution)
1
Model
2
Gunner
Pos.
3
Daisy
Ch.
4
Sound
Arm
On
During operation the keys in the
MOTION column control optional
motion unit movement for the
launcher number noted on the key.
During programming the MOTION
column is used to select the feature
to be programmed.
ARM / ON key
-
This key provides a
safety switch that prevents the unit from
transmitting a launch command when in
the off position. The safety or on condition is
indicated by the display of the red
safety light. The red light indicates
that the unit is armed and ready to
launch.
PROGRAM Key
–
is used to synchronize
and program the transmitter to the launcher.
SEND/CLEAR Key
–
is used to send the
program to the transmitter with the receiver,
or, to reset the order bumpers are launched.
PROG
Send
Clear
Note
The transmitter will automatically disarm after
45 seconds. After this period the ON/OFF key
must be pressed again in order arm the system
.