** The 1/1000 chrono hand will not move to indicate the reading until the end of the timing.
For the above sample hand positions, the exact chrono reading is:
4 hours, 3 minutes and 12.614 seconds.
E) CORRECTING THE CHR0NO HANDS POSITION IF NECESSARY
If the chrono hand positions are not correctly located at the zero starting point
(12 o’clock for all chrono hands except for the 1/1000 retrograde hand which
should start at the “000” mark), then proceed as follows:
1. Pull the crown out to the first click position. Push and hold button “A” to correct the 1/10
chrono hand and the 1/100 hand to the zero or 12 o’clock position. There will be a delay of
about 3 seconds before the hands start to move.
NOTE: These hands are permanently synchronized so that one revolution of the 1/100 hand
equals one tenth of a revolution of the1/10 second hand.
2. Pull the crown out to the second click position. Push and hold button “A” to correct the
1/1000 retrograde hand to the “000” starting position. There will be a 3 second delay as
above
3. With the crown still in the second click position, Push and hold button “B” to correct the
chrono second hand to the zero or 12 o’clock position. There will be a 3 second delay before
the hand moves.
4. Push the crown back in to the normal position.
5. After the necessary corrections, go back to section “C)” for chrono operation.
7
Summary of Contents for 98B267
Page 69: ...阅读下面说明时请参考前面图解 69 操作计时器 ...
Page 89: ...下記操作説明をお読みの際は前述の図をご参照ください 89 クロノグラフ クロノ を操作する ...
Page 98: ...98 1182WB 0927BLGL RV 04 15 ...
