Bullit DVBT-9001, User Manual

Page: 25 / 40

II III
To ensure driving safety, the front screen must be connected to the “Handbrake” control •
cable. This will ensure the driver’s concentration while the vehicle is moving. The driver is
able to watch TV once the handbrake is activated. The rear passenger screens are con-
nected via the “Rear Video Out” control cable and are not under the same restriction.
WARNING
To avoid electrical shock or bodily harm, please ensure the following:
Do not remove enclosure •
Do not allow the unit to be exposed to extreme heat, cold or humid condition •
Do not connect the receiver with excessive voltage than indicated •
Emergency Handling
If the receiver is exhibiting any unusual behaviour, please turn off power immediately and •
contact your dealer for support. Do not attempt to repair the receiver
Safety Guidelines
Suitable for DVB-T reception coverage area •
Receives both VHF & UHF signals •
Contains digital decoder & twin tuners •
Digital decoder will automatically performs error correction, which increases Signal to Noise •
(S/N) ratio and reception capacity
Supports both 4:3 and 16:9 image ratio
•
Receives Standard digital TV programs •
Provides Electronic Program Guide (EPG) function •
CD quality sound, 24 bit processing for stereo sound output •
High quality DVD image. •
SPECIAL ATTENTION
Please use the standard 75 Ohm antennas designed for digital TV. This machine provides •
a +5V DC power used by the antenna. The power can be used by an active antenna.
If the antenna used has an impedance lower than the standard 75 Ohm or has short-
•
circuited, the screen will display an "antenna power overload" warning message. Please
eliminate the antenna short-circuit or exchange it for a standard digital TV antenna.
If no programs can be received, please check first if the antennas are standard DVB-T
•
antennas and if they are connected properly. Use the signal strength indicator and signal
status to make appropriate adjustments to the antenna position. If necessary, use the auto
scan button to re-scan all channels. Still, if no programs can be received, then the receiver
is probably outside the coverage area. Move the receiver to a new location and re-scan.
Details about coverage areas can be found from digital broadcasting organisation web-
sites.
Digital Set-top Box Special features
2-3