Page 30
Bullfrog Spas Owner’s Manual
CHANGING YOUR SPA WATER
Depending on usage, your spa water will need to be
changed approximately every 2-4 months or whenever
your spa water becomes difficult to manage.
Steps to Drain Your Spa:
1. Disconnect electrical power supply.
2. Remove door to Equipment Compartment.
3. Drain water from spa by completing the following:
a. Locate Drain Hose in Equipment Compartment.
b. Lift Drain Hose higher than water level in spa.
c. Remove cap on Drain Hose (Fig. U).
d. Connect garden hose to Drain Hose.
e. Lower Drain Hose to ground level.
Note 1:
Drain water to an area that can handle the
gallonage of your spa.
Note 2:
If draining water onto vegetation, make sure
that the sanitizer level (bromine or chlorine level) of
your spa water is less than .5 PPM.
4. Clean the spa shell (refer to "Spa Shell Care" in this
Owner's Manual).
Steps To Refill Your Spa:
1. Remove garden hose from Drain Hose and replace
Drain Hose Cap.
2. Reattach door to Equipment Compartment.
3. Refill spa with tap water. Fill the spa to any point
between the two Water Level Indentation marks located
on the back wall of the filter/skimmer cavity. The depth
range of these marks is 6-7½” down from top of spa.
Note 1:
The higher the water level, the fewer spa users
it will take to cause the water to overflow the top of the
spa.
Note 2:
Do not fill your spa with soft water unless the
mineral content is raised immediately.
4. Restore electrical power supply.
5. See "Starting Your Spa with New Water" under "Water
Chemistry" in this Owner's Manual.
(Figure U) Drain Cap
(Figure W) Skimmer, Basket & Filter Assembly
