Page 13
Bullfrog Spas Owner’s Manual
CONTROL SYSTEM OPERATION
Important:
Bullfrog Spas come with either an
Standard,
Deluxe
or
Limited
Control System. Please refer only to
the Control System that applies to your spa.
WARNING:
This equipment generates and uses radio frequency
energy and if not installed and used properly, that is, in strict
accordance with the manufacturer's instruction, may cause
interference to radio and television reception. It has been type
tested and found to comply with the limits for a class B
computing device in accordance with the specifications in
subpart J of part 15 of the FCC rules, which are designed to
provide reasonable protection against such interference in a
residential installation. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause interference, which can be determined
by turning the equipment on and off, the user is encouraged
to try to correct the interference by one or more of the
following measures: Reorient the receiving antenna. Relocate
the receiver with respect to the spa. Move the receiver away
from the spa. Plug the receiver into a different outlet so that
the receiver and spa are on different branch circuits. If
necessary, the users should consult the dealer or an
experienced radio/television technician for additional
suggestions. The user may find the following booklet prepared
by the Federal Communications Commission helpful: “How to
identify and resolve radio-TV interference problems.” This
booklet is available from the U.S. Government Printing Office,
Washington, DC 20402, Stock No. 004-000-00345-4.
STANDARD CONTROL SYSTEM
MASTER CONTROL PAD
(Figures J/K)
Temp Set
(80°F - 104°F)
The start-up temperature is set at 100°F. The last meas-
ured temperature is constantly displayed on the LED.
Note that the last measured spa temperature dis-
played is current only when pump 1 (“Jets 1” )has
been running for at least 2 minutes
.
Press the “Temp Set” button to display and adjust the
set temperature. After three seconds, the LED will
automatically display the last measured temperature.
Jets 1
Touch the “Jets 1” button once to activate the low speed
of pump 1 and again for the high speed. Press the “Jets
1” button again to turn off pump 1. If left running, the
pump’s low speed will automatically turn off after 2
hours, and the pump’s high speed will automatically
turn off after 30 minutes. The pump’s low speed runs
when the spa is heating, when a filter cycle is activated,
or when a freezing condition is detected. If the pump’s
low speed is on under Automatic Spa Control, it can
only be deactivated by entering the Standby Mode.
Jets 2
Touch the “Jets 2” button once to activate the low speed
of pump 2 and again for the high speed. Press the “Jets
2” button again to turn off pump 2. If left running, the
pump’s low and high speeds will automatically turn off
after 30 minutes.
(Figure J) Standard Control Pad
(Figure K) S Control Pad
1
2
