BulletHD LITE2, Manual

Page: 4 / 13

BulletHD Overview
① LED ② Power / Shutter ③ Rear Cap ④ Mode Switch
⑤
USB
⑥
MicroSD Card Slot
⑦
Battery
⑧
Microphone
Initial Set Up
1. Make sure the BulletHD is OFF before adding or removing the memory card!
2. Screw out the rear cap (open) located at the back of the BulletHD
③
.
3. Install a micro SD memory card (max up to 32GB) into the rear slot. To insert the
micro SD card, slide the micro SD card into the card slot on the back of the
BulletHD with the card label facing down. The micro SD card will click into place
once it is inserted past flush with the Bullet HD. Use your fingernail to do this. Then
screw in the rear cap till is complete lock.
4. If no micro SD memory is inserted in the Bullet HD, the LED on top of the camera
will blink red and green.
5. When using a micro SD memory card in the Bullet HD, there should be no data
from other devices on the card. If you are using a micro SD memory card for the
first time in the Bullet HD, first you should format the card in your computer.
Charging The Battery
Screw out the rear cap located at the rear of the camera
③
and plug the USB
charger to the camera. The blue light is on while charging, goes off when the battery
is fully charged. On the first use charge the battery 10 hours before use! You can
record up to 125 minutes with one charge.