3.
Wire brush entire outside surface of burner to remove loose corrosion.
4.
Clean any clogged hole with a stiff wire (such as an open paper clip).
5.
Inspect the burner assembly for any opening caused by correction.
6.
Replace burner and put cotter pin back to hole of the cast peg beneath
the burner.
7.
Check the burner for proper location after replacing.
To assure the
valve orifices are inside of the burner tubes. See right drawing. If
the valve orifices do not fit inside the burner tubes, lighting the
burners may cause explosion and/or fire.
IGNITOR
I
ELECTRODE CHECK
With all control knobs set to OFF”, check each igniter individually for presence of spark at electrode. In turn, push each control
knob in fully and turn slowly about a 1/4 turn to the left (counter-clockwise) until a click is heard; the trigger hitting the strike
block should produce a blue spark at the electrode tip. Return control knob to “OFF” before checking next igniter.
BURNER OPERATION CHECK
1. With BBQ Grill control knobs in “OFF” position, turn on the Gas supply.
2. Light any burner by pushing its control knob in fully and slowly (3 to 4 seconds) turning it about 1/4 turn to the left (counter-
clockwise) until a click is heard. The 3 to 4 second duration should provide enough gas to light the burner. If the burner does
not light, immediately return the control knob to “OFF”, wait several minutes for the gas to disperse, and repeat the process.
After burner lights successfully, turn control knob to “OFF”.
NOTE:
Upon
first assembly the gas lines and burners will be full of air. In order for the burners to light properly the lines must fill
with gas. It may require several attempts at lighting the burners before you are successful.
3. Repeat process for each control knob/igniter, in turn, ensuring that other knobs are in “OFF” position as you perform each
check.
4. If any burners fail to light after several attempts, discontinue gas supply at source and re-inspect for obstructions to gas flow
and orifices.
.
7
COOKING COMPONENT INSTALLATION
Summary of Contents for 0-4078
Page 17: ...ILLUSTRATED PARTS LIST 15...
Page 19: ...16...
