Bullet Barbecue 0-4078, Assembly & Operating Instructions

Page: 5 / 19

action of natural gas must be used on all male pipe thread. Apply compound
or tape to at least the first three threads when making the connection.
Remove plastic cap from regulator installed on grill.
Attach stainless steel flex line 3/8” flare-female end to the regulator.
Attached the other end of flex line to shut-off valve thru a nipple.
Attach a shut-off valve to gas supply pipe.
PERFORM GAS LEAK CHECK -SEE PAGE 2
PROPANE GAS CONNECTIONS
The LP gas pressure regulator and hose assembly supplied with this unit
must be used without alteration. If this assembly needs to be replaced, use
only the type 1 specified in the parts list supplied with this unit.
Use a LP tank with a type 1 cylinder valve. Make sure the tank is firmly
secured in an upright position.
Turn the black coupling nut of the hose and regulator assembly in a
clockwise direction. Make sure it is completely threaded onto the cylinder
valve before turning gas supply on.
PERFORM GAS LEAK CHECK — SEE PAGE 2
4
OUTDOORS NATURAL GAS BBQ INSTALLATION SPECIFICATIONS
NOTE:
Vents must be provided for combustion air on both sides of built-in cabinet.
When choosing a location for your gas grill keep in mind that it should never be located under any
overhead combustible construction.
The sides and back of the grill should not be any closer than
21 inches to combustible construction.
DO NOT store empty or full spare tanks under or near this or any other appliance.