When an alert is triggered e.g. Speed, Vibration, Geo-Fence etc, a Push Noti
fi
cation is displayed on
your phone and you can view all alerts in the app by tapping
Alarm
. This will display: date, time tracker
name alert type and address at time of the alert.
IMPORTANT
Alerts can only be set when the tracker is
NOT
in sleep mode.
If the tracker is in sleep mode
Tracker is o
ff
-line
will be displayed.
You can check if the tracker is o
ffl
ine by viewing the tracker on the Map (Tap
Menu
, Map
). If the tracker is not
displayed tap
Tracker Select
and tap the switch to
On
next to your tracker name.
Tap your tracker icon to display the status window. This will show status and location data for your
tracker.
9. NO
TIFIC
A
TIO
N
S
A red circle is displayed showing the area of the geo-fence.
Use the
Geofence diameter slider
to increase or decrease the diameter of the geo-fence circle.
Select the switches for
Enter Alarm
and
Exit Alarm
to select if you are alerted when you enter into the geo-
fence area or exit the geo-fence area.
Tap
Con
fi
rm
The
Status
screen will display after each command is set. After a few seconds if the command is successful
Status:
Send successfully
will be displayed. If an error is displayed e.g.
Tracker is o
ff
-line
, try again later.
Disable
Tap
Menu,
Management, Command, Delete a geo-fence.
Tap
Set a geo-fence
and select the number of the geo-fence to delete
Tap
Con
fi
rm
The
Status
screen will display after each command is set. After a few seconds if the command is successful
Status:
Send successfully
will be displayed. If an error is displayed e.g.
Tracker is o
ff
-line
, try again later.
GE
O-FENCE ALER
TS
5
TR35/201805-15/GEN
Important
The
Bulldog
tracking app, allows for the management and control of multiple vehicles using one log in.
Care should be taken when sending commands to ensure that the correct vehicle is sent the command.
Failure to follow these instructions, where you operate multiple vehicles from one app log in, could result in
vehicle trackers not operating as expected. To send a command to a tracker:
Tap
Menu,
Map.
tap the
Tracker Select
icon and tap the name of the tracker you want to send a
command. (If there are multiple vehicles in the same location, zoom into the map) Tap the icon of the
tracker to bring up the status screen as shown
in Fig 5. (iOS screen shown)
Tap
Command
in the status window and the command screen will be displayed allowing you to select the
required command and this command will be sent only to the selected tracker.
10. MUL
T
I-VEHICLE MANA
GE
MENT
Fig. 5
Status Window
Command function
