7
FOR GENERAL MOTORS CARS ONLY
System 1: PASSKEY I and II system (1985 and up). This system has a resistor pill in the key. Measure
resistance of the pill using a volt/ohm meter. A bypass module is available, part #VATS-WR module.
System 2: PASSLOCK I and II system (1995 and up). Passlock does not have a pill in the key. It
has a light on the dash that states ANTITHEFT OR SECURITY system. A bypass module is available,
part #GMBP-721 module.
System 3: PASSKEY III system (GM 1998 and up). Passkey III is GMs version of a transponder system.
This key will have the letters PK3 on it. A bypass module is available. (Part #781)
FORD ANTI-THEFT SYSTEM: PATS
Ford uses a bypass part #FBP-718 module, 1995-1998. (1999 and up will use part #781.)
CHRYSLER AND MOST IMPORTS ANTI-THEFT SYSTEM: TRANSPONDER
1998 and up will use part #781.
FACTORY ANTI-THEFT SYSTEMS
HOW TO USE YOUR REMOTE TRANSMITTER
Control Module
Antenna Wire
Antenna Tube
antenna clips provided to hold it in place. Be sure to expose the full length of the clear antenna.
It will perform best if mounted vertically, below the dark windshield tint. Never leave antenna
in headliner. Range is up to 800 feet. Each receiver is tested to more than 400 feet (800 feet,
E models) of clear air reception. While many times you will see a higher range. Many factors will
affect the range, including the amount of radio signals in the area, battery strength, window tint,
etc.
ANTENNA
For best results, run the antenna (YELLOW WIRE WITH
BLACK TIP from the back of the unit) as straight
as possible. Do not place the antenna next to any
metal parts or the vehicle’s main computer control
module. Range is up to 400 feet.
E MODEL REMOTE STARTERS
Run the antenna up the windshield pillar on the
driver’s side and across the top of the windshield
to the center, behind the rearview mirror. Use the
Starting the Vehicle with the Remote Transmitter
Press and release Button #1 (start). The parking
lights will flash once, confirming the car
starter received the signal. The car will then
start and the parking lights will turn on and
remain on while the vehicle is running. To shut
off the engine before the preset time, press
Button #2 (stop) or press the brake pedal. NOTE:
If your car does not start on the first crank
it will automatically attempt to start up to 2
more times. (only in tachless mode) In tachless
mode, parking lights will wait approximately 10
seconds before turning on.
BUTTON #1
Starts your vehicle from 400 feet
away. (E-Model, up to 800 feet)
BUTTON #2
Shuts engine off and programs runtime.
BUTTON #3
Locates your vehicle in a crowded
parking lot.
BUTTON #4
Sounds alarm.
BULLDOG
Start
Stop
Finder
Panic
Pit Stop: Exiting the Car with the Engine Running
Make sure the transmission is in park and press Button #1 (start) before turning the ignition switch
off. (The engine will remain running for the preset time.)
Runtime Confirmation (Engine Not Running)
To check programmed runtime, press and release Button #2 (stop), the parking lights will flash
for the programmed length of time.
Finder
Press and release this Button #3 to sound the horn and flash the parking lights to locate your
vehicle in a crowded parking lot.
Panic
Press and release this Button #4, the horn and parking lights will cycle in full panic for 35
seconds.
ANTENNA PLACEMENT
