6
CAUTION: Before connecting the 18-pin
harness to the module, double check all
connections to be sure they are secure
and properly wrapped with electrical tape.
Mount the unit under the driver’s side
dash. Make sure to properly place antenna.
(See antenna placement page 15.) Plug the
18-pin harness into the main control
module. Once it is plugged in, press and
release transmitter button #4, the parking
lights flash 3 times. The flash confirms
that the transmitter code has been
programmed to the unit. Once the module
is programmed, connect the 3-pin harness
from the 4-relay harness to the module.
NOTE: There are several wires in the 18-
pin harness that will not be used. All
unused wires must be taped.
Press the start button, the parking lights
will flash once and the vehicle will start
and run. If your vehicle starts and remains
running and you wish to connect your door
locks, proceed to page 16, “Testing Door
Locks”, and follow the provided instructions.
NOTE: If your vehicle does not start and
run you may have a factory anti-theft
system. Refer to pages 15 and 21 to see
if this applies to your vehicle.
CONNECTING THE 18-PIN HARNESS & 4-RELAY HARNESS
BROWN/BLACK
GREEN/BLACK
BLACK/WHITE
BLACK/BLUE
BLUE
VIOLET
WHITE/RED
ORANGE
BROWN
GRAY
GRAY/BLACK
YELLOW
BLUE/BLACK
BLACK/YELLOW
GREEN
RED/BLACK
BLACK
RED
(+) or (-) Door Lock pulse
(-) or (+) Door Unlock pulse
Tach (-) to neg. side of coil
(-) To hood pin switch
(-) Aux. alarm channel input
(-) Dome light supervision
(-) Trunk release
(not used)
(+) Parking lights
(not used)
(not used)
Ignition input
(+) Brake switch
(not used)
(not used)
(-) Factory alarm shutdown
Ground
To +12V constant
WHT/BLK 16 ga.
WHITE 16 ga.
YEL/BLK 16 ga.
RED
2 Red wires need
+12V constant.
Either white
wire to Ignition
1. If your car
has 2 ignitions
use both.
To Starter/Crank
Wire
To Heater/Blower
Motor Wire
RED
WHITE
WHITE
YELLOW/BLACK
WHITE/BLACK
Tap here when
installing bypass
module 721.
WHITE 16 ga
WHT/BLK 16 ga
YEL/BLK 16 ga
For Passlock I
For Passlock I
For Passlock II
750ma (-)
Outputs
YELLOW
ANTENNA
Keep as
straight as
possible,
tape end
to hold
straight.
ANTENNA PLACEMENT
E MODEL REMOTE STARTERS
Run the antenna up the windshield pillar on the
driver’s side and across the top of the windshield
to the center, behind the rearview mirror. Use
the antenna clips provided to hold it in place. Be sure to expose the full length of the clear
antenna. It will perform best if mounted vertically, below the dark windshield tint. Never leave
antenna in headliner. Range is up to 800 feet. Each receiver is tested to more than 400 feet
(800 feet, E models) of clear air reception. While many times you will see a higher range. Many
factors will affect the range, including the amount of radio signals in the area, battery strength,
window tint, etc.
Control Module
Antenna Wire
Antenna Tube
ANTENNA
For best results, run the antenna (YELLOW WIRE
WITH BLACK TIP from the back of the unit) as
straight as possible. Do not place the antenna
next to any metal parts or the vehicle’s main
computer control module. Range is up to 400 feet.
