LIGHTING & OPERATING INSTRUCTIONS
LIGHTING PROCEDURES
Lighting Burner(s):
1. Become familiar with the safety guidelines at the front of the manual.
DO NOT SMOKE WHILE LIGHTING POWER BURNER OR CHECKING
GAS SUPPLY CONNECTIONS!
2. If your
power burner fuel source is a LP gas cylinder, check to see that the cylinder is filled.
3. Check that the end of the burner tube is properly located over the burner orifice and the ventri tube cap and brass cap are properly seated on
the ventri tube.
4. Make sure all gas connections are securely tightened.
TEST FOR LEAKS WITH A SOAP SOLUTION, NEVER WITH A FLAME
. (Gas Leak
Check instructions are on page 2).
5. Always remove lid before lighting.
6. Set ALL power burner control knobs to “OFF” and open gas supply, LP cylinder or Natural Gas Valve.
7. Ignite only the burners you intend to use, using the same method for each: Push in control knob completely and rotate slowly (3 to 4 seconds)
about 1/4
turn to the left (counter clockwise) until a click is heard. The 3 to 4 second duration should provide enough gas to light the burner. If the
burner does not light, immediately return the control knob to ‘OFF’, wait several minutes for the gas to disperse, and repeat the process. After
burner ignites, repeat procedure if the other burner is needed.
8. Adjust control knob(s) to desired cooking temperature.
NOTE:
If igniters fail to produce a spark at the electrode tip, burners can be manually lit with a fireplace-type match.
NOTE:
To light power burner with a fireplace-type match
, follow steps 1 through 6 above. Remove grates. Insert lighted fireplace-type match or
long-necked butane lighter placing flame near to burner ports. Press in control knob and rotate left to “HIGH” setting to release gas. Burner should
light immediately. If more than one burner is needed, repeat procedure with the other burner. Replace grates. Adjust burner(s) to desired cooking
temperature.
OPERATING PROCEDURE
Burn-off:
Before cooking on your power burner for the first time, burn the power burner to get rid it of any odors or foreign matter by igniting the
burners and operating at “HIGH” setting for about five minutes. You may then either set the controls to “OFF” or cook on your power burner
immediately by turning the control knobs to a lower setting.
This power burner has been certified with a pot size of 60 qt in total volume, 15 1/2” in height and 18” in diameter.
CAUTION: DO NOT LEAVE POWER BURNER UNATTENDED
WHILE IN USE.
CAUTION:
If burners go out during operation, close gas supply at source, and turn all gas valves off. Wait five minutes before attempting to re-light
(this allows accumulated gas fumes to clear).
CAUTION:
Should a grease fire occur, close gas supply at source, turn off all burners and leave lid off until fire is out. Do not use water or any
liquid to extinguish a grease fire.
CAUTION:
Do not attempt to disconnect any gas fitting while your power burner is in operation or while gas feed is on.
12
Summary of Contents for 96000
Page 17: ...EXPLODED ILLUSTRATION 16...