12
LP GAS TANK RETENTION GUIDELINES
NOTE: AN LP TANK (CYLINDER) WITHIN AN ENCLOSURE MUST USE A TANK RETENTION SYSTEM TO
PREVENT BEING KNOCKED OVER.
Below are the requirements with supportive illustrations for an LP Tank enclosure and how to
install a Tank Retention System which can be obtained through your Bull Dealer:
Per CSA the following is required that any built-in cabinet must have enough room for only
1 LP tank. The LP tank enclosure must not exceed (24.5” X 24.5” X 30”) and there must be a
minimum clearance of 2 inches between the floor and the propane tank enclosure.
Any Tank Retention system must be securely fastened to the island floor using bolts with washers
and nuts. There must be a minimum clearance of 2 inches between the floor and the cylinder
enclosure. Once secured, place the LP tank in the tank retention system and tighten the tank
retention bolts clockwise until the tank is held snug and cannot move. Turn the retention bolt counter-
clockwise to free the tank for removal.
WARNING:
DO NOT STORE AN EMPTY, SPARE OR DISCONNECTED LP GAS CYLINDER UNDER OR NEAR
THIS GRILL OR ANY OTHER APPLIANCE.
DO NOT USE A DENTED OR RUSTY LP GAS CYLINDER AS THIS MAY BE HAZARDOUS.
WARNING:
IF THESE GUIDELINES ARE NOT FOLLOWED, A FIRE CAUSING SERIOUS INJURY OR DEATH MAY OCCUR.
Summary of Contents for 69008
Page 5: ...4 ...
