Bull Cedoc Bull Escala 2104 DS4, Operator'S Manual

Page: 10 / 117

Electrostatic discharge (ESD)
Attention: When you handle field-replaceable units (FRUs) and other computer
parts, take these precautions to avoid static damage:
v
Limit your movement. Movement can cause static electricity to build up around
you.
v Always touch the computer parts carefully. Hold the cards by their edges or metal
cover. Never touch any exposed circuits.
v
Prevent people who are not correctly grounded from touching computer parts.
v Before you install a new part, touch the static-protective package that contains
the part against an unpainted metal part of the 2104 Model DS4, 2104 Model
TS4, or host system for at least 2 seconds. This reduces the static electricity in
the package and in your body.
v
Remove the part from its package and, if possible, install it directly into the 2104
Model DS4 or Model TS4 without putting the part down. If you must put the part
down, follow these steps:
1. Place the static-protective package that contained the part onto a smooth,
level surface.
2. Place the part onto the static-protective package. Do not place the part
directly onto any metal surface.
Safety inspection procedures
The safety inspection procedures describe how to inspect the 2104 Model DS4 or
Model TS4.
CAUTION:
The 2104 Model DS4 and Model TS4 are designed to be installed by the
customer and are certified as customer setup. Make sure that the system or
rack into which the 2104 Model DS4 and Model TS4 will be installed is also
designed and certified for customer setup. If the 2104 Model DS4 and Model
TS4 are not, then they must be installed by a CE. (22)
Inspecting the rack
Refer to your rack installation manual for information about performing a safety
inspection on the rack.
viii
Expandable Storage Plus 2104 Model DS4 and Model TS4 Operator’s Guide