8
Auxiliary handle
The auxiliary handle (8) will provide additional control, support and guidance for the drill.
Slide the holder of the side grip over the drill chuck on the machine.
Turn the side grip in the required position and tighten it firmly.
Depth gauge
The depth stop is used to limited the maximum drilling depth.
Loosen the side grip (8).
Insert the depth stop (9) in the hole in the holder of the side grip.
Adjust the depth stop to the required drilling depth.
Tighten the side grip firmly.
Inserting SDS Max accesories
Clean tools with a thin layer of machine grease before fitting
Push and rotate the dust-free tool into the tool holder as far as it will go. The tool will lock
automatically.Check that it has locked by pulling the tool
Removing SDS Max accessories
Pull back fastening sleeve,hold and remove tool
Operation
Do not use for hammer-drilling or chiselling accessories without SDS Max
system
Selecting the operation mode
Hammer drilling
:for drilling in concrete or hard stone, reactivate the hammer action by
rotating back the switch (5) to the position
Chiselling
:deactivate the drilling action by turning the selector (6) until the mark coincides
with the arrow on the selector lever.
Dust collection device
Before performing hammer drilling work vertically overhead pull dust collecting device over the drill
bit.
Switching ON and OFF
Connect the tool to the power supply.
To start the machine, you squeeze the ON / OFF switch (4). To stop the machine, you release the
ON / OFF switch.
Cleaning and maintenance
Before performing any work on the equipment, pull the power plug.
Cleaning
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
Regularly clean the machine housing with a soft cloth, preferably after each use.If the dirt
