Buick Encore GX Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-
16263917) - 2023 - CRC - 2/24/22
212
Driving and Operating
Warning (Continued)
ahead, or enter your lane. Also see
“
Alerting the Driver
”
later in this section.
Complete attention is always required
while driving and you should be ready to
take action and apply the brakes. See
{
Warning
ACC will not detect or brake for children,
pedestrians, animals, or other objects.
Do not use ACC when:
.
On winding and hilly roads or when
the camera sensor is blocked by snow,
ice, or dirt. The system may not
detect a vehicle ahead. Keep the
windshield and headlamps clean.
.
When visibility is poor due to rain,
snow, fog, dirt, insect residue, or dust;
when other foreign objects obscure
the camera
’
s view; or when the
vehicle in front or oncoming traffic
causes additional environmental
(Continued)
Warning (Continued)
obstructions, such as road spray. ACC
performance is limited under these
conditions.
.
On slippery roads where fast changes
in tire traction can cause excessive
wheel slip.
.
With extremely heavy cargo loaded in
the cargo area or rear seat.
.
When towing a trailer.
5
:
Press to turn the system on or off. The
indicator turns white on the instrument
cluster when ACC is turned on.
RES+ :
Press the control up briefly to
resume the previous set speed or to increase
vehicle speed if ACC is already activated. To
increase speed by about 1 km/h (1 mph),
press RES+ up briefly. To increase speed to
the next 5 km/h (5 mph) mark on the
speedometer, hold RES+.
SET
−
:
Press the control down briefly to set
the speed and activate ACC or to decrease
vehicle speed if ACC is already activated. To
decrease speed by about 1 km/h (1 mph),
press SET
–
down briefly. To decrease speed
to the next 5 km/h (5 mph) mark on the
speedometer, hold SET
–
.
*
:
Press to disengage ACC without erasing
the selected set speed.
[
:
Press to select a following gap setting
for ACC of Far, Medium, or Near.
The speedometer reading can be displayed
in either English or metric units. See
. The increment
value used depends on the units displayed.
