Buhnen HB 720 R/S, Translation Of The Original Operating Manual

Page: 19 / 52

General
19
1 General
Please read this Operating Manual through carefully and completely before first using the
Applicator. Pay particular attention to the safety instructions in Section 2.
This Operating Manual must always be within easy reach for any user.
1.1 Scope of use
The HB 720 R/S applicator is for the melting and metered discharge of melts (thermopla-
stic substances such as hot-melt adhesives, waxes, etc.) as a bead or spray-on coating
using interchangeable application tools (use as intended).
2 Safety instructions
2.1 Potential hazards
Attention: Burn hazard!
Should hot melt adhesive come into contact with your skin, cool it immediately with cold
water. Do not attempt to remove the hot melt adhesive from your skin. Consult a doctor if
necessary.
Should hot adhesive come into contact with your eyes, immediately cool them under
running water for 15 minutes. Consult a doctor immediately.
Attention: Burn hazard!
Nozzle, molten adhesive and the areas marked with warning labels can be over 200 °C
hot.
Only touch these areas with insulated thermal gloves.
Caution: Avoid danger of tripping!
Avoid tripping accidents:
All equipment connections such as cables, hoses and lines must be laid to eliminate any
risk of tripping. This can be achieved by installing cable conduits and bridges.
Danger!
Never point the operation-ready device at people.
Danger from high pressure!
Risk of Explosion!
When working with oxygen or combustible gases there is risk of explosion!
Odour nuisance!
Hot-melt adhesives give off fumes which can cause odour nuisance – so ensure adequa-
te ventilation.
Improper use may in isolated cases lead to irritation of the mucous membrane. In this
case seek immediate medical advice!
Note
Always work with insulated thermal gloves and safety glasses.
GB
H2200XM_DE-EN_200720.indd 19 26.07.21 08:55