9
ACCESS THE GLOBAL PARAMETER MENU
1. With machine unplugged from A/C power supply, remove the six (6) screws securing the Control
Interface (Legend Plate and Main PCB) to the Control Panel.
2. Remove the Control Interface and turn it over.
3. Locate DIP Switch 1 and 2 on the Main PCB, see
illustration at right.
4. Turn DIP Switch 1 to the “ON” position.
5. Turn over Control Interface. And secure to Control panel.
6. Plug in machine to A/C power supply of appropriate
voltage.
7. “0” should be shown in the Display.
8. Press and release Cycle Start button to cycle through
the six parameters (0, 1, 2, 3, 4, 5).
9. Use the Travel Speed Adjustment knob to change the
parameter setting.
10. When finished, unplug machine, remove Control
Interface and turn it over.
11. Turn DIP switch 1 to the “OFF” position to lock global
parameter menu.
12. Re-assemble Control Panel and plug in machine to begin operation.
CONVERTING UNITS
By default, the K-BUG 4000 will be factory set to operate in English units (in/min) and the K-BUG
4002 will be set to operate in Metric units (cm/min). If it is necessary to change units, follow the steps
to access the Global Parameters Menu, above. Use the Cycle Start button until “5” is shown on the
Display. Turn the Travel Speed Adjustment knob right or left to select the desired Units. Choose “U1”
for Metric (cm/min) or “U2” for English (in/min).
Rear of Main PCB. Note DIP switch
placement on left hand side. Move
Switch 1 up to the ON position.
GLOBAL PARAMETERS, CONT’D
