6
SETUP
AVC-2060 Plasma Height Control
This is available as original equipment or as a retrofit unit designed to provide Plasma Height Control
on BUG-O Modular Drive Systems (MDS) with the Pendulum Weaver (WPD-2100).
CAS-1500-18 Height Slide Assembly
This replaces the Gun Mounting Group originally supplied on the Pendulum Weaver. To install, begin
by remove the WPD-2050 Gun Mounting Group from the weaver, [Refer to Modular Drive System
Instructions and Parts Manual]. Install Pendulum Weaver Adapter CAS-1558. Slide clamp on bottom of
Height Slide Assembly CAS-1500-18 onto the CAS-1558 and lock in position.
CAS-1558 Pendulum Weaver Adaptor
SENSOR OPTIONS FOR PLASMA POWER SOURCES
Manufacturer
Model
AVC
Sensor
Option
AVC
On/Auto
Switch
Position
Additional Connection Instructions
ESAB
®1
Cutmaster 82 with full-
featured automation
interface PCB option
-ID
Auto
Contactor wires plug into AVC-1550, which
sends them to the plasma source.
Hypertherm
®2
Powermax45 XP
®
with
CPC port and voltage
divider
-ID
Auto
Contactor wires plug into AVC-1550, which
sends them to the plasma source.
Hypertherm
®
Powermax65
®
with
CPC port and voltage
divider
-ID
Auto
Contactor wires plug into AVC-1550, which
sends them to the plasma source.
Hypertherm
®
Powermax85
®
with
CPC port and voltage
divider
-ID
Auto
Contactor wires plug into AVC-1550, which
sends them to the plasma source.
Hypertherm
®
Powermax105
®
with
CPC port and voltage
divider
-ID
Auto
Contactor wires plug into AVC-1550, which
sends them to the plasma source.
Hypertherm
®
Powermax125
®
with
CPC port and voltage
divider
-ID
Auto
Contactor wires plug into AVC-1550, which
sends them to the plasma source.
Hypertherm
®
Powermax1650
®
-RV
Auto
AVC-1002 will need to be installed and will
need to connect to J15 and J16. Contactor
wires will need to be connected to the AVC-
1550 and then AVC-1003 (sold separately) can
connect the AVC-1550 to the machine inter
-
face connection for arc start and arc transfer.
Lincoln
Electric
®3
Tomahawk1538
®
-RV
On
AVC-1002 will need to be installed and will
need to connect to the EL2 and OUT1. Con
-
tactor wires will need to connect to the Toma
-
hawk’s accessory connector. A competent
person must determine how to best make
these connections.
