Buffalo TeraStation 5010, User Manual

Page: 168 / 176

167
LCD Message Description Corrective Action
Date and Time
Date Time
YYYY/MM/DD
hh:mm
Displays the date and time set in the
TeraStation.
-
IP Address
LANx DHCP
192.168.11.150
Displays the IP address. If acquiring from a
DHCP server automatically, "DHCP" will be
displayed. If configuring a static IP address,
"Static IP" will be displayed.
-
LAN2
Port Trunking
Displays if port trunking is configured. -
Errors
LCD Message Description Corrective Action
Invalid Firmware
The firmware is corrupted and the
TeraStation boots in emergency mode.
Update the TeraStation firmware to recover
from emergency mode by following the
procedure in the "Booting the TeraStation
in Emergency Mode" section above. If the
error is displayed again, contact Buffalo
technical support for assistance.
E10 UPS Running Off
Battery
The TeraStation is running on the UPS
battery due to a power outage.
Shut down the TeraStation safely and wait
until the power outage ends. If certain
settings are configured, the TeraStation
may shut down automatically when the
error is detected.
If the setting to use the UPS connected to
this TeraStation has been configured, the
UPS cable may be disconnected.
Verify that the UPS cable or LAN cable is
connected properly.
If the setting to use the UPS connected to
another TeraStation on the same network
has been configured, the LAN cable of this
TeraStation may be disconnected.
E11 Fan Failure An error occurred in the fan speed.
Check that no foreign objects or dust are
clogging the fan. If any foreign objects or
dust are found, use a pair of tweezers, air
duster, or other tool to remove them. If the
error is displayed again, contact Buffalo
technical support for assistance.
E12 Cooling Failure
A rise in the system temperature may have
exceeded the allowable safety value.
Do not place objects in the area around
the TeraStation. Also, move the TeraStation
to a cool location.
E14 Can't Mount
Array x
RAID array x cannot be mounted. Run the RAID array disk check in Settings.
E16 Drive x Not
Found
Unable to find drive x.
Drive x may be disconnected or may have
failed. After shutting down, reinstall the
drive.
E22 Can't Mount
Drive x
Unable to mount drive x.
Format the drive. After formatting, if the
error still appears after rebooting, replace
the drive. If the error is displayed again,
contact Buffalo technical support for
assistance.