NAS HARDWARE PREPARATION
1) Mount drives on supplied NAS drive racks, install drives in NAS
2) Connect network cable
3) Connect power supply
4) Turn on NAS, rear switch above network connector. Fan turns on.
Wait, observe LED’s
5) Front panel LED sequence after power up
Wait a few seconds
- White LED flashing / Red LED off
Wait a few minutes, then
- White LED flashing / Red LED solid on
Wait a few seconds, then
- White LED solid on / Red LED solid on
6) Press the initialize button (front panel above USB) for a few seconds, release
Wait, observe LED’s
7) Front panel LED sequence after initialize button is depressed and released
Wait a few seconds
- White LED solid on / Red LED flashing
Wait about 10 minutes – drive format and data writing from NAS hardware
- White LED solid on / Red LED off
8) NAS drives are prepared. NAS is ready for configuration.
If all goes well as mentioned above, go to step 9. Else go to RUNNING
LSUPDATER PROGRAM – NO DATA ON DRIVES to assist in NAS drive
formatting and initialization.
9) Run NAS Navigator program
- Navigator will display all Link/Tera-Stations on your network
- Upon first startup of NAS, the NAS IP Address will be DHCP assigned
- NOTE NAS FIRMWARE VERSION reporting in Navigator (bottom right)
10) Right click on highlighted NAS in detail window. Select Properties
11) Change NAS to static IP Address if desired
Go to RUNNING LSUPDATER PROGRAM – NO DATA ON DRIVES
