7
UK
Disconnecting a gas cylinder
• Except for twin-cylinder installations with a
changeover valve, turn off the gas tap if fitted
to the appliance. Wait until the burner and pilot
light have gone out. For installations with a
changeover valve, it is only necessary to switch
off the empty cylinder.
• Replace the orange safety cap onto the empty
cylinder.
Operation
Seasoning the cooking surfaces
before first use
• Make sure the cooking surfaces are clean.
• Apply a generous amount of oil to the griddle
plate.
• Turn on all 6 knobs to the high position “
”.
• Wait 5 minutes, switch off and carefully wipe
any excess oil from the plate.
Preparation before cooking
• Wipe clean the cooking plate. Let dry
thoroughly.
• To prevent foods from sticking to the cooking
surface, apply a light coat of cooking/vegetable
oil before each barbecuing session.
• Do not face directly over the gas griddle when
lighting.
Note: When cooking for the first
time, cooking surfaces colour
may change slightly. This is
normal and does no indicate any
defect.
Lighting the gas griddle
1. Ensure all control switches of the gas griddle
are at
OFF
position.
2. Turn on gas supply.
3. To ignite a burner, push and turn the burner
control switch to
HI
(Fig. 4).
4
4. Press the electric igniter and hold for 3-5
seconds to light the burner (Fig. 5).
5
Warning: If ignition does
not occur in 5 seconds, turn
the burner switch and wait
5 minutes. Then repeat the
lighting procedures.
5. Follow same steps to light the other burners.
Manual ignition
Should automatic ignition fails,
1. Remove the griddle.
2. Turn the switch anticlockwise to
HI
position.
3. Light with BBQ lighter at the distance of 5mm
to the burner fire hole.
4. Replace the griddle, ensuring to wear heat-
resistant gloves.
Caution!
• If the lighting still fails
after 2 attempts, turn the
control switch to OFF. Wait 5
minutes for the unburnt gas
to evaporate. Afterwards,
re-light.
• For any difficulty with
lighting, please consult your
dealer.
CY265_UK_A5_v1_20191121.indb 7
2019/11/21 15:19
