LST12 15 Ton Log Splitter
5
IMPORTANT SAFE OPERATION PRACTICES
Operation
1. Before starting this machine, review the “Safety Instructions”. Failure to follow these rules may result in
serious injury to the operator or bystanders.
2. Never leave this machine unattended with the engine running.
3. Do not operate machine while under the influence of alcohol, drugs, or medication.
4. Never allow anyone to operate this machine without proper instruction.
5. Always operate this machine with all safety equipment in place and working. Make sure all controls are
properly adjusted for safe operation.
6. When loading a log, always place your hands on the sides of the log, not on the ends, and never sue your
foot to help stabilize a log. Failure to do so, ma result in crushed or amputated fingers, toes, hand, or foot.
7. Use only your hand to operate the controls.
8. Never attempt to split more than one log at a time unless the ram has fully extended and a second log is
needed to complete the separation of the first log.
9. For logs which are not cut square, the least square end and the longest portion of the log should be
placed toward the beam and wedge, and the square end placed toward the end plate.
10. Always keep fingers away from any cracks that open in the log while splitting. They can quickly close and
pinch or amputate your fingers.
11. Keep your work area clean. Immediately remove split wood around the machine so you do not trip over it.
12. Do not change the engine governor settings or overspeed the engine. The governor controls the
maximum safe operating speed of the engine.
13. This machine should not be towed on any street, highway or public road without checking the existing
federal, state, or local vehicle requirements. Any licensing or modifications such as taillights, etc., needed
to comply, is the sole responsibility of the purchaser. If a “Statement of Origin” is required in your state,
see your local dealer.
14. Do not tow machine over 15 mph and do not move this machine while the engine is running.
15. See “Towing The Log Splitter” section in this manual for proper towing instructions once all federal, local,
or state requirements are met.
Maintenance and Storage
1. Stop the engine, disconnect the spark plug and ground it against the engine before cleaning or
inspecting.
2. Stop the engine and relieve hydraulic system pressure before repairing or adjusting fittings, hoses, tubing,
or other system components.
3. To prevent fires, clean debris and chaff from the engine and muffler areas. If the engine is equipped with
a spark arrester muffler, clean and inspect it regularly according to manufacturers’ instructions. Replace if
damaged.
4. Periodically check that all nuts and bolts, hose clamps, and hydraulic fittings are tight to be sure
equipment is in safe working condition.
5. Check all safety guards and shields to be sure they are in the proper position. Never operate with safety
guards, shields, or other protective features removed.
6. The pressure relief valve is preset at the factory. Do not adjust the valve.
