ITEM # EPW1300 Electric Pressure Washer Assembly & Operating Instructions
4
HOW TO USE DETERGENTS
Detergents are not required when using the pressure washer. However, some stubborn jobs may need detergent.
THE PRESSURE WASHER CAN DISPENSE DETERGENT AT A LOW PRESSURE. BIODEGRADABLE
DETERGENTS ARE SPECIFICALLY FORMULATED TO PROTECT THE ENVIRONMENT AND YOUR PRESSURE
WASHER. THESE DETERGENTS WILL NOT CLOG THE FILTER AND WILL PROTECT THE INTERNAL PARTS OF
THE PRESSURE WASHER FOR A LONGER LIFE.
Step 1
Separate the nozzle from the detergent container by turning the detergent reservoir counter clockwise and separating
the two components.
Step 2
Fill the detergent container with approved detergent. Pour the detergent slowly into the reservoir using a funnel.
Reattach the two components by reinserting the nozzle back onto the detergent reservoir and turning clockwise.
USE OF EXTENSION CORDS
Use of an extension cord with this product is NOT RECOMMENDED. If you must use an extension cord, use only
extension cords that are intended for outdoor use. These cords are identified by a marking “ACCEPTABLE FOR USE
WITH OUTDOOR APPLIANCES, STORE INDOORS WHILE NOT IN USE.” Use only extension cords having an
electrical rating not less than the rating of the product. Examine the extension cord before use. DO NOT USE
DAMAGED EXTENSION CORDS! Do not pull on cord to disconnect from receptacle, always disconnect by
pulling on plug. Keep cord away from heat and sharp edges. Always disconnect the extension cord from the
receptacle before disconnecting the product from the extension cord.
OPERATING INSTRUCTIONS
USE WITH COLD WATER ONLY! DO NOT USE HOT WATER IN THIS PRESSURE WASHER!
TO START
After connecting the pressure washer to the cold water supply, proceed as follows:
Make sure that the POWER switch is in the OFF position.
Make sure the unit has been assembled:
Connect the garden hose to the inlet fitting.
Insert the adjustable spray nozzle into the gun.
Connect the high pressure hose to the high pressure outlet fitting.
Connect the high pressure hose to the gun.
Connect the gun to the specified detergent nozzle.
Open the water supply valve completely.
Before turning the unit on, press the gun trigger to bleed all the remaining air out of the pump and hose.
Start the pressure washer by turning the power switch to the on position and squeeze the trigger.
REMINDER: Motor does not run continuously, only when the trigger is squeezed.
WARNING
- RISK OF INJURY! Unit will start spraying when trigger is squeezed. When turning the unit off after use,
high pressure still exists inside the hose and unit. Point the gun in a safe direction and discharge the excess pressure.
NEVER direct the high pressure water stream at people or animals.
