Buffalo Tools 800449, Assembly & Operating Instructions

Page: 6 / 16

4.5 Inch Metal Cutting Bandsaw Assembly & Operating Instructions 6
IMPORTANT SAFETY INSTRUCTIONS
Before using this tool, you need to become familiar with its operation. If you are unsure about
the operation of the tool, or have any questions about its proper use, call the Customer Service
Department at 1-888-287-6981. Follow these instructions for safe handling of the tool:
•
Be sure your work area is clean and secure. Be sure the area is free from all foreign material,
nails, staples, or any other material .
•
Always use the appropriate safety gear when operating. Including but not limited to, goggles,
dust mask or respirator.
PACKAGE CONTENTS
• Bandsaw
COMPONENTS
ASSEMBLY
Before performing any assembly or maintenance, make sure bandsaw is turned off and unplugged
from the power supply
.
BANDSAW MUST BE GROUNDED. Use a Ground Fault Interrupter (GFI). Plug the power cord to a
standard 120 volt receptacle protected by a 20 amp circuit breaker.
The bandsaw comes partly assembled. It is therefore necessary to complete the assembly as follows.
Unpack and layout all the items and identify each one.
Attach lower tray, wheels and handle in this order.
Assemble vice handle to shaft on end of main base (bed) and tighten set screw.
1. Motor Assembly
2 . Belt Adjusting Bolt
3
.
Pulley Guard
4
.
Gearbox
5.
On-Off Switch Assembly
6
.
Left Leg
7 . Right Leg
8 . Tool Tray
9
.
Wheel Assembly
10.
Handle
11
.
Work Stop Assembly
2
4
10
11
5
6
8
1
3