h.
Use a cable strap from the kit to bind the left side
hand grip wire, turn signal wire and handlebar
switch harness together.
i.
Route the
left side
switch wiring harness along the
same path as the original switch wires,
through
the opening in the headlight housing.
j.
Route the
left side
heated grip harness through
the same opening in the headlight housing.
k.
Continue routing the left side handlebar switch
wiring harness and heated grip harness along the
vehicle main wire harness to the connector location
beneath the headlight assembly.
1
3
2
4
is04647
Cable strap
1.
Second cable strap
2.
Heated grip wire
3.
Harness retainer (2)
4.
Figure 8. Bind Heated Grip Wire to Handlebar Switch
Harness (Ulysses Models)
13.
For Firebolt models:
Proceed to Step 14.
For Lightning
models:
Proceed to Step 18.
For Ulysses models:
Proceed to Step 23.
For 1125R models:
Proceed to
Step 28.
For 1125CR models:
Proceed to Step 33.
HEATED HAND GRIP WIRE CONNECTION,
FIREBOLT MODELS
1.
Proceed to the area under the fairing. See Figure 9. Refer
to the service manual, and follow the instructions to
connect the black four-way socket housing on the right
side handlebar switch assembly to vehicle harness pin
housing [22A] (1). If previously disconnected, connect
the black eight-way socket housing on the left side
handlebar switch assembly to vehicle harness pin
housing [24A].
1
5
4
3
2
is04685
Right side handlebar switch connector to
vehicle harness
1.
Auxiliary power connector on vehicle harness
2.
Auxiliary power connector on handlebar
switch harness
3.
Protective plug installed to handlebar switch
harness
4.
Heated grip to handlebar switch harness
connectors (2) tucked between headlights
5.
Figure 9. Connect Heated Grip and Handlebar Switch
Wiring (Firebolt Models)
2.
Locate the gray auxiliary power connector [160] (2) on
the main vehicle harness. Remove the protective plug,
and connect the gray pin housing (3) at the end of the
right side handlebar switch harness to socket housing
[160B]. Install the protective plug to the gray socket
housing (4) at the end of the right side handlebar switch
harness.
3.
Connect the two three-way heated hand grip wire pin
housings to the two socket housings at the end of the
right side handlebar switch harness. Tuck the two heated
grip wire connectors (5) up between the headlights.
4.
Obtain two cable straps from the kit, and secure the
bundle of wires and connectors beneath the dash.
Proceed to the
RETURN TO SERVICE
section.
HEATED HAND GRIP WIRE CONNECTION,
LIGHTNING MODELS
1.
Proceed to the area behind the windscreen. See Figure
10. Route the right side heated grip wire (1) and right
side handlebar switch harness (2) behind the turn signal
flasher (3) and out over the horn (4). Refer to the service
manual for instructions to connect the black four-way
socket housing on the right side handlebar switch
assembly to vehicle harness pin housing [22A]. If
previously disconnected, connect the black eight-way
socket housing on the left side handlebar switch
assembly to vehicle harness pin housing [24A].
-J04491
5 / 9
