Buell Blast 2014, Service Manual

Page: 390 / 408

7-56 2004 Buell P3: Electrical
HOME
Left Side
1. Attach switch housing to handlebar with three screws.
Tighten screws to 25-33 in-lbs (2.8-3.7 Nm).
2. See Figure 7-73. Route switch housing wiring harness
between front forks. Attach connector [24] and connector
[95] to wiring harness. Fasten wiring harness behind
dash with new cable straps.
1 1
WARNING
1
WARNING
Check all handlebar switch operations before riding
motorcycle. Handlebar switches not operating properly
could result in death or serious injury.
3. See Figure 7-74. Check handlebar switch for proper
operation. If operation fails, reread procedure and verify
that all steps were performed.
a. Turn ignition key switch to IGN.
b. Check headlamp LOW and HIGH beam settings.
c. Set headlamp to LOW beam. Press passing lamp
switch. Headlamp should flash HIGH beam for as
long as the switch is pressed.
d. Check left and right turn signals.
e. Activate horn by pressing horn switch.
f. Turn ignition key switch to OFF.
Figure 7-73. Left Handlebar Switch Connection [24] and
Clutch Switch Connection [95]
Figure 7-74. Left Handlebar Switches
V
GY
LBE
O
2
BE
GN
BK
BN
W
RIGHT TURN
9
8
7
6
5
3
1
W
Y/BK
V/BN
BN
O
Y
BE
HORN POWER
LEFT TURN
FROM FLASHER
HIGH BEAM
HORN
LIGHT POWER
LOW BEAM
R/BE
TN/GN BK 2
1 BK
TO GROUND
TO STARTER RELAY
a0260x7x
[95]
[24]
1. Passing lamp
2. HIGH beam
3. LOW beam
4. Turn signals
5. Horn
1
2
4
5
3
7079