Applications manual
|
25
GB125 Concentric Vent
Design Manual
GB125 Concentric Vent Design Manual | 05.2009
Technical specifications are subject to change without prior notice
Stainless Steel Chimney Cover for UB Flex
The stainless steel cover replaces the composite top and
end pipe.
Table 13
Part Number
Description
7747208685
Stainless Steel Chimney Cover for GAK System
with UB Flex
Only the stainless steel pipe is UV proof and may be
exposed to the elements above the roof.
Cut off the smooth part of the UB Flex pipe and adjust its
length so that it ends approximately 1” above the
chimney crown where the chimney cover will be sitting.
Disassemble the union and observe the arrow on the
main body dictating the direction of the flue gases. The
gray gasket faces up.
Slide the threaded ring with the threads facing up over
the UB flex pipe. Slide the split ring with the flange facing
up over the corrugated UB flex pipe, and snap into the
second grove. Slide the red gasket over the corrugated
UB flex pipe and snap into the very first grove.
Now insert the pipe so prepared into the main body of the
union and screw the threaded ring in hand tight.
Open the hose clamp, slide the union through from
below, and let its upper collar rest against the clamp.
Tighten the hose clamp until the union is held firmly in
place.
Set the complete chimney cover with the UB Flex pipe
attached onto the chimney.
When looking down into the chimney, you should see a
fairly straight pipe. If major twists and turns occur, loosen
the hose clamp and pull up on the union. If the pipe still
has a lot of slack, disassemble the union and shorten the
UB Flex pipe carefully. Reassemble and verify the pipe is
now straight.
Using a pair of snips, the chimney cover can be trimmed
to to match the chimney crown. Mark and drill 4 holes,
and insert wall anchors. Caulk around the perimeter of
the cover to prevent rain water from entering the
chimney. The removable top of the Chimney Cover
comes with a wire leash to prevent it from taking off
during service. Insert its loop underneath the cover at
one of the corners and slide a screw through it. Screw all
4 corners down firmly.
Coat the gray gasket and the mating stainless steel pipe
with CENTROCERIN®, insert the stainless steel end pipe
into the union, set the top cover on to the pipe, and slide
down as far as it goes.
Fig. 22 UB stainless chimney top
1 Stainless steel end pipe
2 Top cover
3 Attachment piece for the UB flex pipe
4 Chimney Cover
5 UB flex pipe
Not shown: Screws and wall anchors (4); steel cable to secure top
during service
Fig. 23 UB flex connector
1 Stainless steel end pipe
2 Chimney Top
3 Chimney Cover
4 Attachment piece for the UB flex pipe
5 Red gasket
6 UB Flex pipe
7 Split ring
8 Screw bottom
