Bucktool BD4603, Instruction Manual

Page: 16 / 24

15
BELT HORIZONTAL SANDING
SANDING INSIDE CURVES
BELT VERTICAL SANDING
SANDING OUTSIDE CURVES
When using the sanding belt in the horizontal
position, to perform surface or edge sanding,
the belt worktable (1) must always be used.
Always hold the workpiece (2) firmly keeping
your fingers away from the sanding belt (3).
Always keep the end of the workpiece against
the belt worktable (1) and move the work
evenly across the sanding belt (3). Apply only
enough pressure to allow the sanding belt
to remove material. Use extra caution when
sanding very thin pieces.
With care, freehand sanding of inside curves
can be accomplished on the idler drum (1).
Never attempt to sand the ends of a
workpiece on the idler drum (1).
Your belt/disc sander - belt station can sand vertically as well as horizontally.
Depending on operator needs and the workpiece, the worktable can be used
with either the horizontal or vertical position.
To change from one position to the other:
1. Loosen the inner hex screw (1) by turning
it counterclockwise with the 5 mm hex key.
2. Manually move the work support station
into the vertical or horizontal position, as
required.
3. Retighten the inner hex screw (1) by
turning it clockwise.
Freehand sanding of outside curves should be done on the sanding disc (1).
Keep fingers a minimum of 1 in. (25.4 mm) from the sanding disc.
BD4603
OPERA
TING INSTR
UCTIONS
2
3
1
1
1