INSPECTION
Prior to each use, carefully inspect this equipment for indications of wear or deterioration. The inspection should
include, but not be limited to the following:
unit is free from cracks, excessive wear or corrosion.
unit is properly assembled and all screws are in place, fully seated and properly tightened.
the slot and the wheel of the BuckWheel Assembly are free of dirt, debris and ice build up (excessive
build up may cause improper operation of this unit).
wheel and rollers rotate freely without any binding.
If any evidence of wear / deterioration as outlined or any unusual conditions not outlined above be observed, or you
have reasonable doubt about a particular condition, immediately remove the equipment from service and notify your
Supervisor, Safety Director or contact Buckingham Mfg. (1-800-937-2825) for clarification.
CLEANING
The BuckWheel may be cleaned by using a cotton swab, limited air pressure or dipping it into a container of water to
remove fine particles and any foreign matter which may enter around wheel pin and prevent proper function. The
exterior should be dried with a clean cloth. The inside should be air-dried and re-lubricated as needed.
MAINTAINENCE
Lubricate as often as required to maintain smooth operation (no binding) with a lightweight lubricant such as WD-40
®
.
Do not excessively lubricate, wipe away any excess lubricant with a clean dry cloth.
STORAGE
Proper cleaning, maintenance and storage of your equipment will prolong its useful life and contribute toward its
performance. Your equipment should be stored and transported so that it does not come into contact with debris,
moisture, or chemical agents.
BUCKINGHAM MFG. INC.
1-800-937-2825
E-mail – sales @buckinghammfg.com
Web site – www.buckinghammfg.com
487Inst-Warn.doc (Rev. 02/08/11) P/N 230217 Page 3 of 3
