INSTRUCTIONS
To Install the BuckTooth to the Outer Strap of the WPFPD:
A. Remove the four screws from the BuckTooth assembly.
B. Remove the Back Plate to expose the strap slot.
C. Mount the Body / Tooth Assembly to the center of the Outer Strap by placing the Outer Strap in
the strap slot of the Body / Tooth Assembly (Fig. 1a).
Caution:
Make sure that the Body / Tooth Assembly is mounted so that the tooth will be against
the pole and that the point of the tooth will point towards the ground (Fig. 1b).
Fig. 1a
Fig 1b
D. Place the Back Plate on the Body / Tooth Assembly and align the holes (Fig 2a).
E. Insert and securely tighten the four screws (Fig 2b).
Fig. 2a
Fig. 2b
When properly mounted the BuckTooth should look as shown below with tooth pointing towards the
pole and the ground.
NOTE: When re-adjusting the WPFPD hardware locators to the 3
and 9 o’clock positions it will be necessary to adjust the
BuckTooth so that it is always at the rear of the pole
(12 o’clock position).
485InsRevisedBT.DOC Page 2 OF 3
P/N 230184 Rev. 02/04/11
