User manual for BTR Solar light
Please read this manual carefully before using your product for the first time.
Should you find the light diffuser broken, it is probably caused by occasional damages
during transportation, please contact the seller/distributor for replacement.
Please keep this manual in good condition, as you might need it for the battery
replacement in future.
Specification:
Satinless Steel
Poly-Crystal Solar panel
Powerful SMD 5630 LED - 0.5W
3.2V - 1000m Ah Li-ion battery
3000K
Assembly and Placement:
Step 1: Carefully remove all the parts from the box.
Step 2: Assemble all the parts by following the image listed below.
Step 3: Place the light into the ground as shown in the image and turn the ON/OFF
switch to “ON” mode, make sure the solar light is placed in a position where
sunlight will reflect on the solar panel free from cover and shade.
Step 4: Make sure the solar panel is not going to be illuminated by any other light
sources; otherwise the light will not be able to switch ON at dusk.
In order to prevent any dommage and to ensure proper operation of your light, the
replacement battery need to be the same model as original (3,2V - 1000m Ah Li-ion
battery).
Care and Maintenance:
Clean the solar module regularly with a damp towel to guarantee optimum
performance of the solar panel. Do not use any type of solvent for cleaning and be
careful not to put too much pressure on the module while cleaning.
The built-in rechargeable batteries need to be replaced after several years
(depending on the climate conditions and number of charging cycle ). To replace the
battery, please follow the steps below:
Troubleshooting:
If the solar light does not work at dusk after a full day charge, please try the following steps:
1. Make sure the solar panel is not being affected by any other light source.
The built-in sensor will activate the light only when the surrounding is dark.
2. Make sure the solar light is not positioned in the shade during the day.
3. Make sure the switch is in “ON” mode.
If the switch is still in “OFF”, the batteries could not be charged.
4. Check if the batteries are correctly installed and in good condition.
Your light use Solar Radiation, a Renewable Energy to charge the battery. Don’t confuse light
exposure and Solar Radiation exposure!
Depending your living area and the season, the direct normal solar radiation in kilowatt-hours
per square meter per day (kWh/m2/d) can be significantly lower. The variation of the Solar
Radiation can impact drastically the charge of the battery and the time of illumination per day.
For example in winter your Solar panel need to get longer exposure to Solar Radiation to
charge fully battery. If your battery cannot be charged well due to weather and season’s
condition, your illumination at night can be shorter than normally tested in direct normal solar
radiation.
BTR Lighting contact information:
North America head office:
Betterlighting USA, Inc.
1811 NE 146th ST
North Miami - FL 33181
USA
Tel: +1 786 955 6358
Fax: +1 786 955 6128
E-mail: [email protected]
European head office:
Betterlighting Germany GmbH
Verkaufsbüro: Hansaring 7
63843 Niedernberg
Germany
