10 of 12
BTOD.com • 866.733.0698 • Email: [email protected]
If the leg assemblies are at uneven heights, it is usually caused by an improperly installed hex rod. Disassemble one
of the leg assemblies from the worksurface and make sure both ends of the hex rod are properly engaged in the hex
drives near the top of the leg assemblies.
Note
Save for Reference
Standard Switch
Start Up Procedure:
•
Plug the power cord into a standard 110V receptacle. A power surge protector
is recommended.
•
Press the down arrow until the worksurface reaches its lowest position.
•
The workstation is ready for use.
• If the table is not functioning normally or has lost power, perform the reset procedure.
Reset Procedure:
•
Unplug the unit from the wall for 10 seconds.
•
Clear all obstructions from the travel path of the desk.
•
Plug the unit back in the wall.
•
Press and hold the down arrow key until the table reaches its lowest position.
Add Container Stops:
•
Move the table to the upper or lower desired height.
•
Rapidly press 4 times. You will hear a musical tone.
•
Rapidly press 2 times. A musical tone plays two times.
- To
add
the
upper
container stop press A musical tone plays two times.
- To
add
the
lower
container stop press A musical tone plays two times.
Remove Container Stops:
•
Move the table to the upper or lower
preset
height.
•
Rapidly press 4 times. You will hear a musical tone.
•
Rapidly press 2 times. A musical tone plays two times.
- To
delete
the
upper
container stop press You will hear a musical tone.
- To
delete
the
lower
container stop press You will hear a musical tone.
Troubleshooting:
If you are having any problems with the operation, contact Beyond the Office Door at
866.733.0698
or
