2
TECHNICAL SHEETS
HD/HC/HS4434 - L/N/NT4434N - AM5434
BT00476-a-UK
≥ 2,5 m
1 m
2,5 m
Positioning the detector
Installation
The detector must be
positioned in such a way
that it is not disturbed
by the artificial light that
is already present in the
room.
Parameters of detection:
Configuration
Time delay:
Lenght of time the load is kept “on” after the last detection.
Sensitivity:
Detection range setting.
Modes:
Auto on/Auto off mode:
Automatic switch-on:
- On detection of presence if the natural light level is insufficient.
Automatic switch-off:
- If no presence is detected and at the end of the time delay set.
- Or if the natural light level is sufficient (activated setting range).
Another detection causes automatic switch-on if there is insufficient light.
Walkthrough:
- If a presence is detected for less than 20”, the product will cut off the load after
3 minutes.
- Otherwise, the device will cut off the load at the end of the time delay set.
Manual on/Auto off mode:
Manual switch-on, automatic switch-off:
- When no presence is detected and at the end of the time delay set.
After a switching off, if the sensor detects a presence within 30 seconds it
automatically turns on again the light; after 30 seconds the light has to be
manually turned on.
Sensor parameters
Default value
Modifiable parameters
Configuration tools
BMSO4001
BMSO4003
Time delay
15 mn initially
Tripper position
3, 5, 10, 15, 20 min
−
5s - 59 min 59s
−
Sensitivity
PIR (very high)
Low, medium, high, very high
Modes
Auto on/Auto off
Inactive
Activate/Deactivate
Walkthrough
Inactive
Activate/Deactivate
Manual on/Auto off
Active
Activate/Deactivate
Det
ec
tion
sy
st
em
Initial
PIR
Non-modifiable
−
Maintain
PIR
Non-modifiable
−
Retrigger
PIR
PIR/Deactivate
−
Alert
Inactive
Activate/Deactivate
−
