2
24/03/2016
BT00056-c-
HA/HB/L4619
Z N
AU
X
MOD
Z
MOD
N
AUX
EN
The device requires allocation of the zone it belongs to, the progressive number of the
sensors within the same zone, and the setting of the detection mode, as well as the
possible allocation of an auxiliary prealarm channel.
WARNING: The configuration operations must be performed with the battery
disconnected
Z
This configurator assigns the number of the appropriate zone to the detector.
Configurator 1 assigns zone 1 to the detector, configurator 2 assigns zone 2 and so on to a
maximum of 8 zones Configurator 9 assigns the device to the group of auxiliary devices.
N
N= 1 – 9 Progressive number in the zone
MOD
Do not configure.
AUX
The configurator in the AUX socket activates the auxiliary function of the corresponding
auxiliary channel. It therefore enables controlling auxiliary actuator devices, provided
that they have been configured using the same auxiliary channel.
Note: to complete the activations using the relay actuator type HD/HC/ HS/L/N/NT4614
and AM5794 see the appropriate technical sheet.
Pairing remote controls
1.
Switch the system to “maintenance” mode.
2.
Press the programming pushbutton of the radio receiver for five seconds, until the
red LED comes on.
3.
Press the RESET key for 5 seconds.
4.
If the pairing of the device has been performed correctly, the red LED of the radio
receiver will go off.
If this does not happen, repeat the procedure from step 3. If the LED flashes, it
means that the device memory is full.
5.
To pair other devices, repeat from step 2.
6.
Perform self learning of the system from the central unit.
7.
Program the remote controls on the central unit.
8.
Exit “maintenance” mode.
Configuration
Radio flooding
detector
Internal view
Cancelling remote controls
1.
Switch the system to maintenance mode.
2.
Remove the power supply from the receiver.
3.
Press and hold the programming pushbutton while reconnecting the power supply
to the radio receiver.
4.
After 5 seconds the LED flashes orange. If the pushbutton is released at this time,
only the remote controls are cancelled.
5.
After releasing the pushbutton, the LED becomes fixed orange. When the LED goes
off, cancellation has been completed.
6.
Perform self-learning of the system from the central unit and exit “maintenance” mode.
