3
•
Function setting
1 .Configuration using the keypad
1.1Access to the configuration menu
Press and hold down keys
for more than 10 seconds
Enter the access code (default 1234)
If the correct code has been entered, direct access to the configuration menu will
be granted
To exit the configuration menu, or to return to the previous menu, select EXIT and
press “OK”
1.2 If the password is forgotten
If the password has been forgotten it’s possible to reset it in this way:
Press the “RESET” key which on the back of the device for about 6s. password
recover the default “1234”.
1.3 Panel settings
Select the menu
, Confirm “OK”
1.3.1Device settings
The DEVICE SETTINGS submenu can be used to set the following functions:
Brightness Display brightness adjustment
Contrast Contrast adjustment(Not used)
Exit return to the previous menu
1.3.2 Password setup
To change the access password:
Press “OK” ,Enter the new password “6789”
Confirm “OK”
1.3.3 Home page
The home page can be used to enter a customised welcome message, or any other
message;
the message can use a maximum of three rows of text of 15 characters (Template); to
switch
from upper case to lower case and vice versa use the arrow keys. The length of time
the - message is displayed on the screen (5, 10, or 15 sec.) (Timeout).
Entering the text, Press “OK”
Select the row
where to enter the new text, or change the existing
text and confirm “OK”
Press “OK” to select the text field
Enter the text using the alphanumeric keypad, in the same way as you would write an
SMS message on your mobile phone
Confirm “OK”
The new message will appear continuously on the home page for the period set a
Timeout
1.3.4Restore default settings
Select the function
, Press “OK”
Press “OK”
The settings of the entrance panel revert to the factory settings. This function does not
delete the data contained in the residents address book.
1.4 Address book
This menu can be used to enter residents’ data, including call codes and door lock
release codes, as well as for performing any other functions described in the following
paragraphs.
1.4.1 Calling mode - List of names
This setting determines how the names of the residents are displayed; if enabled, the
display
will show the following message:
