11
Tool change
Caution!
Do always remove the power plug before carrying out any work on the tool.
You may catch your fingers when inserting the tool. Therefore, do always
wear protective gloves when changing tools.
The work spindle of the tool is provided with a M14 internal thread.
Keep thread and front surfaces clean.
Do use a SW 22 spanner to remove the stirrer and to hold up the work
spindle.
Switching the machine on and off
Short-Time Operation
Starting the machine: Press on/off switch
Stopping the machine: Release on/off switch
Permanent Operation
Starting the machine: Press on/off switch and while keeping it pressed,
engage the lock button
Stopping the machine: Press on/off switch again and release it
Warning!
Do only use the lock button if the tool is operated with the supporting stand.
If a standstill caused by the tool or a power failure occurs, do immediately
loosen the lock button by pressing the on/off switch in order to avoid the
unintended restart of the tool (risk of injury).
The mixer has an electronic switch in order to regulate the speed level by
keystrokes.
It is recommended to only use it when the machine is started or stopped in
order to avoid splashing material. If the continuous mode is operated with
reduced speed, it leads to overstress because the machine is not provided
with enough cooling air and overheating will occur significantly faster.
Summary of Contents for 9 094948
Page 1: ...Rührwerk RW 1300 Art Nr 9 094948 ...
Page 16: ...15 ...
