VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
39
1.
Press the
key to enter the menu.
2.
Enter
on your numeric keypad to come to Menu 11: R-CTCS
3.
Press the
key to select.
Insure you have a tone activated (selected) and it is not off.
4.
Press the
to begin CTCSS scanning
A flashing "CT" will be in the left status display to indicate the radio is in CTCSS scanning mode.
In this mode, whenever the radio is receiving an RF signal on the selected MR channel or VFO
frequency, the lower display will cycle through the CTCSS tones as they are being tested. Once
the frequency of the received CTCSS tone is determined, the "CT" indicator will stop flashing.
Press the
key to save the scanned tone into memory then press the
key to exit the
menu.
Don't forget to set VFO menu 11 back to OFF when the CTCSS tone is no longer
required.
Scanning for a DCS tone
1.
Press the
key to enter the menu.
2.
Enter
on your numeric keypad to come to Menu 10: R-DCS
3.
Press the
key to select.
Insure you have a tone activated (selected) and it is not off.
4.
Press the
to begin DCS scanning
