6- 2
Service Manual
LWE130
© BT Europe AB
Drive unit/drive gear – 2000
Service and repairs
T-code
Valid from serial number
Date
Order number
675
914369-
2005-09-23
226057-040
6.2 Service and repairs
6.2.1 Dismantling the motor from the truck
•
Shutdown the truck, pull out the plug from the start block.
•
Remove the hoods from the battery compartment.
•
Loosen the battery connections.
•
Lift out the batteries.
•
Loosen the two screws holding the instrument panel.
•
Place the instrument panel in the truck.
•
Seal the oil-filling plug.
•
Loosen the connections on the tiller arm.
•
Dismantle the cover plate and the two nuts on the tiller arm.
•
Lift off the tiller arm.
•
Place the truck on its side.
•
Loosen the four bolts on the motor’s chassis mounting.
•
Carefully lift out the motor and place on a clean surface.
Essential service and repair work can now be carried out on the motor.
•
Assembly takes place in the reverse order.
6.2.2 Inspection/replacement of the carbon
brushes
•
Shut down the truck, pull out the plug from the start block.
•
Remove the hoods from the battery compartment.
•
Loosen the battery connections.
•
Lift out the batteries.
•
Loosen the two screws holding the instrument panel.
•
Place the instrument panel in the truck.
•
Seal the oil-filling plug.
•
Refit the instrument panel.
•
Place the truck on its side.
•
Dismantle the covers from the carbon brushes.
•
Loosen the cable connections are push back the carbon brush
springs.
•
Pull out the carbon brushes and inspect/measure the wear. (See ta-
ble)
•
Assembly takes place in the reverse order.
https://www.besttruckmanuals.com/