BT FREEHAND, User Manual

Page: 7 / 20

5 Plug the mains power
cable into the unit
The socket for the mains adaptor is at
the back of the phone. Push the plug
in firmly to ensure it is fully inserted.
6 Switch on the mains
power to your Freehand
The unit will produce a burst of
noise followed by a confirmation
beep. While setting up the unit the
HEADSET
button and
SPEAK
button
may flash alternately. This is due to
poor positioning. In this event
Plug in here
Warnings
1
Do not try to use any power supply
except the one provided, as it may
permanently damage your Freehand.
2
Your Freehand should not be
situated in wet or damp conditions,
for example in a bathroom.
3
There is a slight chance that your
phone could be damaged by an
electrical storm. We recommend
that you unplug the unit from the
mains during storms.
reposition the unit and repeat the
setup procedure.
Your Freehand is now ready for use.
7 Setting the speaker/
ringer volume
The ringer and speaker volume of
your Freehand can be altered using
the
VOL
(volume) button.
•
Press the
▲
part of the
VOL
button to increase the volume.
•
Press the
▼
part of the
VOL
button to decrease the volume.
As you press the
VOL
button,
your Freehand will generate a ring
that indicates the new ringer
volume.
VOL
Setting up
7
Changing the speaker volume during
a conversation
Increase or decrease the speaker volume
during a telephone conversation, using
the same procedure as above. When the
volume is set to a maximum or
minimum position the
SPEAK
button
will light up, if an intermediate level is
chosen the button will only illuminate
after releasing the
VOLUME
button