Brush Bandit 1290XP, Operating & Parts Manual

Page: 23 / 140

Bandit
INSERT Copyright 11/14
SAFETY PROCEDURES
SAFETY PROCEDURES
The ANSI required control bar is designed to reverse the feedwheels when pushed. Check the direction
and proper operation of the control bar before operating the chipper.
WARNING
!
CORRECT OPERATION OF FEED CONTROL BAR
OFF
PUSH TO
REVERSE
FEEDING
FEEDING
EXPLOSION HAZARD : Ultra low sulfur diesel
(ULSD) poses a greater static ignition hazard than
earlier diesel formulations with higher sulfur content.
Avoid death or serious injury from fire or explosion;
consult with your fuel or fuel system supplier to
ensure the delivery system is in compliance with
fueling standards for proper grounding and bonding
practices.
WARNING
!
If the discharge or hood need to be removed,
always use some sort of mechanical device like an
overhead hoist, loader, lift truck, etc. that is rated for
lifting that component. Follow all OSHA instructions
for lifting.
Before opening or closing the feedwheel trap
door: disengage clutch, turn off engine, wait for the
disc/drum to come to a complete stop, install the
disc/drum lock pin, disconnect battery, and make
sure the ignition key is in your possession. In the
event that dirty material is being run through the
chipper the feedwheel trap door can be opened.
DANGER
!
DANGER
!