PAGE 6
BRUNSWICK INSTALLATION MANUAL
BLACK WOLF
ATTACHING BILLIARD CLOTH TO
UNFRAMED SLATE
Before attaching the billiard cloth, clean slate thoroughly.
FIGURE ONE
Step #1:
Lay the bed cloth over the top of the slate, nap
side up. Leave an equal amount of cloth overhang at the
ends and sides of the slate.
FIGURE ONE
FIGURE TWO
Step #2:
At the head end of the table, fold the cloth back
away from the edge of the slate and spray a coat of
contact adhesive (not included) as indicated by the
shaded area of the edge of the slate. Hold the can
approximately 4-8" from the area to be coated. Coat the
underside of the slate also. Place a piece of protective
paper or card board on the top surface of the cloth.
CAUTION:
Do not allow any adhesive to get on the top
surface of the cloth.
FIGURE TWO
FIGURE THREE
Step #3:
Attach the cloth at #1.
Step #4:
Stretch the cloth across the table at #2. Fold
the cloth overhang underneath the edge of the slate at
the end.
Step #5:
Fold the cloth back at the foot end of the table
and repeat Step 1.
Step #6:
Stretch the cloth from #1 to #3 and press into
position.
Step #7:
Stretch the cloth #3 to #4, pulling from #1 and
#2. Press into place.
FIGURE THREE
PROTECTIVE
PAPER
EDGE OF SLATE
BOTTOM OF
SLATE
#2
#1
#3
#4
