Bruno REGAL CUB 35, Operator'S Manual

Page: 21 / 64

© 2001 BRUNO INDEPENDENT LIVING AIDS, INC.
21
EACH TILLER HAS 2" OF HEIGHT ADJUSTMENT
[ ] Using a 5/32 Allen Wrench remove Screws, then remove
the Upper Front Cover Plate before adjusting height.
[ ] Loosen *(DO NOT REMOVE) 5/16" Bolt Head facing
seat (1/2" Nut Driver Required)
[ ] When desired height is acquired tighten Bolt Head and
replace Upper Front Cover Plate.
* WARNING: IF YOU REMOVE 5/16" BOLT, THE LOCK
PLATE INSIDE OF TILLER WILL DISASSEMBLE
REQUIRING EXTENSIVE DISASSEMBLY TO REPAIR
ANGLE ADJUSTMENT
[ ] The Tiller has a complete range of motion within 110
degree range
[ ] You can position the tiller very easily by pressing in the
release lever and moving the tiller into the desired
position. This can be done one handed or if more
leverage is required, while holding in lever, push or pull
using the Handlebars.
[ ] When release lever is not pushed in, Tiller is locked into
position.
[ ] Do not try adjusting tiller while moving.
TILLER HEIGHT ADJUSTMENT
TILLER HEIGHT ADJUSTMENT
TILLER LOCK
OPERATION
PUSH TO
DISENGAGE
LOOSEN FOR
HEIGHT
ADJUSTMENT
(DO NOT REMOVE)
REMOVE
SCREWS
UPPER FRONT
COVER PLATE
NOTE:
AS A SAFETY
PRECAUTION, REVERSE
SPEED IS LIMITED
TO 60% OF
MAXIMUM FORWARD
SPEED.
NOTE:
FOLD TILLER BEING
CAREFUL NOT TO
DAMAGE LIGHT
SWITCHES
CAUTION:
WHEN LOWER TILLER
BOOT IS OFF BE
CAREFUL TO KEEP
FINGERS AND HANDS
AWAY FROM MOVING
PARTS
LOWER TILLER
BOOT