CARE INSTRUCTIONS
Careful and proper cleaning of the surfaces of your ray table is particularly important to keep it in optimum condition.
The following cleaning instructions are only intended as a recommendation. Brunner GmbH will not be held liable for
damage to the finish caused by improper cleaning.
Cleaning the aluminium frame
For normal use, it is sufficient to wipe the metal surfaces with a clean, dry dust cloth. Any particularly dirty areas can be
cleaned with a standard, grease-dissolving all-purpose cleaner. Tarnished areas on the polished surface can be polished up
with chrome polish. Never use abrasive cleaning agents, as well as toilet or sanitary cleaners. The gliders' surfaces should be
regularly cleaned of coarse pieces of dirt or deposits.
Cleaning the powder-coated under-frame
For normal use, it is sufficient to wipe the powder-coated surfaces with a clean, soft, slightly damp cloth. Any particularly
dirty areas can be cleaned with a standard, grease-dissolving all-purpose cleaner. However, abrasive cleaning agents and
WC or sanitary cleaners must not be used because they may damage the powder-coated surface. Acid or alkaline cleaning
agents and organic solvents must also not be used. Please only use soft cotton cloths for cleaning purposes and never use
plastic sponges, wire wool or steam jet devices, which could permanently damage the surface. The gliders' surfaces should
be regularly cleaned to remove coarse pieces of dirt or deposits.
Electrification and cabling | Care instructions
16 . 17
