Connecting Directly to the GEM
©
Brultech Research Inc.
8
www.brultech.com
Steps
1.
Search for WiFi networks and click on “GreenEye_xx” to connect.
2.
Open a browser and set the address to 192.168.2.2 and press “Enter”. A “Sign In” box should
come up prompting for a “User” and “Password”. If so, then skip to step 4.
3.
If the browser did not connect to IP address “192.168.2.2” in the previous step, the PC may not
be set to “obtain an IP address automatically”. Modify the PC’s network settings to do so then
repeat the steps in this section. If you don’t know how to change this network setting, then
search “how to obtain an IP address automatically” on the internet for instructions for your
operating system.
4.
A “sign in” box will prompt for a user name and password. Use “admin” for both.
A web page as displayed in Figure 6 will open. This is the interface used to setup the communication
module to connect to the Network.
Figure 6
N
ETWORK
C
ONNECTION
O
PTIONS
Two options are available to connect the GEM to a network, “WiFi” or “Ethernet”.
WiFi Connection
This option consists of connecting to the network wirelessly. This method is usually preferred as long as
the GEM is within acceptable RF range of the WiFi Router it will be connected to.
Ethernet Connection
An Ethernet connection consists of connecting a network cable between the GEM and a network router
or hub. This method is preferred when a WiFi connection is impractical due to signal range or if a
dependable connection is desired.