Bruker BMPC/2, Technical Manual

Page: 105 / 136

105 Z31823_00_05
Configuration (administrator)
When a channel is not to be represented in the corresponding display then position „0“
must be selected for this field.
12.3.3.2 Event & Data Log
In this settings window you can adjust the properties of the Event Log and the Data Log.
Figure 12.18Tools - Options - Event & Data Log
1.
Event Log
(see also "Present Values / Event Display" on page 31 )
The following possibilities can be selected:
Unlimited
: The log data will be saved until the maximum disk space has been
reached.
Number of lines
: The maximum number of event log entries can be selected.
When the maximum number is reached, the oldest entry will be overwritten.
Number of days
: A maximum number of days for which the event log will be stored
can be selected. When the maximum number is surpassed, the oldest entry will be
overwritten.
2.
Data Log
(see also "Data Log Display" on page 29 )
The same adjustments are available for the Data Log as the Event Log. In addition,
there are also several adjustment possibilities for the frequency of entries:
Data Log Interval
: Here you can select the interval time for the Data Log. You can
chose between the 3 minutes and up to 24 hours. If you select 3 minutes, for exam-
ple, the complete data set will be written to the data log every 3 minutes. The rec-
ommended interval is 1 hour.