BRP Sea-Doo MOVE I 1250 Long Galvanized/Painted Black, Operator'S Manual

Page: 21 / 68

21
T Tiig gh htte en niin ng g T To orrq qu ue e
U-bolts nuts
27 ± 3 Nm (20
± 2 lbf-ft)
Winch arm
adjustment
bolt
27 ± 3 Nm (20
± 2 lbf-ft)
B Bu un nkkss
The bunks (wooden or roller type)
must be adjusted according to the
shape of the PWC hull. They must rest
flat on the flat surfaces of the hull.
B Bu un nkk A An ng glle e ((M MO OV VE E II a an nd d M MO OV VE E IIII
S Se erriie ess))
To adjust the angle:
1. With the PWC off the trailer, loos-
en the bolts retaining the bunks to
their supports.
2. Load the watercraft on the trailer
and make sure that the bunks rest
flat on a flat part of the hull as
shown.
If the bunks do not rest on a suit-
able part of the hull, refer to appro-
priate
Bunk Height and Lateral
Position
section.
M MO OV VE E II -- W WO OO OD DE EN N B BU UN NK K S SH HO OW WN N
1. Bunk square with hull
2. Bolt
M MO OV VE E IIII -- W WO OO OD DE EN N B BU UN NK K S SH HO OW WN N
1. Bunk square with hull
2. Bolt
3. Tighten bolts to specified torque.
T Tiig gh htte en niin ng g tto orrq qu ue e
Bunk retaining
bolts
21 ± 3 Nm (15
± 2 lbf-ft)
B Bu un nkk H He eiig gh htt a an nd d L La atte erra all P Po ossiittiio on n
((M MO OV VE E II S Se erriie ess))
W WA AR RN NIIN NG G
A Allw wa ayyss sse ett b bo otth h b bu un nkkss tto o tth he e
ssa am me e h he eiig gh htt a an nd d lla atte erra all sstta an ncce e..
To change the height and position:
N NO OT TE E::
The height can be changed at front of
the bunks only.
1. Remove the PWC from the trailer.
2. If the height has to be changed, re-
move the front support U-bolts.
3. Install the U-bolt in the holes corre-
sponding the desired height, but
do not tighten yet.
TRAILER SET-UP