14 of 24
Position lever on remote control joint. Align
splines of lever with splines of joint. Neutral lock
lever must align with neutral lock plate. Secure
lever with screw and washer. Torque screw to 7
ft. lbs. (10 N·m).
Align wire and shield to prevent rubbing before
installing control lever cover.
IMPORTANT:
Trim/tilt wire must be routed as
shown in diagrams. Refer to
Remote Control
Configuration Diagrams
.
Install Remote Control Cables
Remove two screws and back cover from remote
control housing.
Use
Triple-Guard
®
grease to lubricate all moving
mechanisms, trunnion pockets, and remote
control cables.
Install shift cable and flat washer on to shift pin
and secure with
new
cotter pin. Bend cotter pin
as shown.
004887
1. Shield, solid side down
0049306
1
004867
004910
WARNING
Always use new cotter pins and bend both
sides of cotter pin as shown to prevent
interference with remote control housing
or possible dislodging of cotter pin from
mounitng pin.
1. Shift cable
004885, 004889
1
Summary of Contents for 5006180
