E-319
PAGE 7 OF 9
Yellow
Blue
Incorrect
Flame
Correct
Flame
Very hot while in operation!
Never lean over the appliance while it is in use.
Do not touch the stone or the spark guard while
the appliance is in operation. Wait until the
appliance has cooled down after use.
Failure to comply with these instructions
may result in serious bodily injury.
WARNING
!
Use of your appliance
causes carbon residue
to build up on the lava
rocks inhibiting the
airflow and leading to a
more yellow flame.
Stir up the lava rocks
regularly to remove
these deposits and
maintain a blue flame.
Step 3
Step 4
SAFETY INSTRUCTIONS
This outdoor appliance is not intended to be
installed in or on recreational vehicles and/or boats.
1. Only use the regulator with hose assembly
supplied with your appliance. A replacement
regulator with hose assembly must be the one
specified in this manual.
2. Have your Propane gas tank filled by a reputable
propane gas dealer and visually inspected and
requalified at each filling.
3. Never fill the gas tank beyond 80 percent full.
Have your propane gas dealer check the release
valve after every filling to ensure that it remains
free of defects.
4. Always keep propane gas tanks in an upright position.
Do not store (or use) gasoline or other flammable
vapours and liquids in the vicinity of this appliance.
5. Propane gas tanks not connected for use must
NOT be stored inside of the appliance or in the
vicinity of this or any other gas appliance.
6. Do not subject the propane gas tank to excessive heat.
Never store an propane gas tank in a garage or any
other indoor location. Always disconnect the propane
gas tank first and store it safely outside.
7. Propane gas tanks must be stored outdoors in a
well-ventilated area and out of children’s reach.
Disconnected propane gas tanks must not be stored in
a building, garage, or any other enclosed area.
8. When your appliance is not in use, the gas must
be turned off at the gas tank.
9. The regulator with hose assembly should be
inspected before each use. If there is excessive
wear, any abrasions, or if the hose is cut, it must
be replaced prior to use of the appliance.
10. Keep the gas regulator hose away from hot
surfaces. Avoid unnecessary twisting of the
hose. Visually inspect the hose for cuts, cracks,
excessive wear, or damage prior to each use of
the appliance. If the hose is damaged DO NOT
use the appliance. Call 1-877-539-7436 for an
authorized replacement hose.
11. Never allow children to play near your appliance.
The store where you made your purchase
does not stock parts for this item.
If you need parts,
whether they are missing or damaged,
STOP!
Missing A Part?
No Need To Go Back To
The Store
Call us between 9:00 AM and 4:30 PM
Eastern Time Monday through Friday
For further assistance,
please visit us at
Call Toll Free:
TEL: 1-877-539-7436
FAX: 1-877-539-7439
READ THESE INSTRUCTIONS COMPLETELY BEFORE STARTING ASSEMBLY
SEPARATE AND IDENTIFY ALL OF THE PARTS, MAKING SURE THAT
YOU HAVE ALL OF THE PARTS LISTED.
IF YOU DO NOT LOCATE ALL OF THE PARTS LISTED, INSPECT THE
PACKING MATERIAL FOR SMALL PARTS THAT MAY HAVE BECOME
SEPARATED DURING SHIPMENT.
IF YOU EXPERIENCE ANY DIFFICULTY DURING ASSEMBLY OR IF ANY
PARTS ARE MISSING OR DAMAGED, CALL THE HELP LINE AT
1-877-539-7436 BEFORE RETURNING THIS ITEM TO THE STORE.
PROVIDE THE FOLLOWING INFORMATION WHEN CALLING:
1-MODEL NUMBER OF THE PRODUCT.
2-PART NUMBER AND MATERIAL CODE OF THE PART FROM THE PARTS
LIST.
MOST PROBLEMS CAN BE RESOLVED WITHOUT RETURNING THIS
PRODUCT TO THE RETAILER.
Warranty
• This product is covered by Creative Courtyards international limited (samoa), taiwan branch Inc.'s. one–year
limited warranty.
• Proof of purchase (dated register receipt) is required for warranty claims.
• It remains the customer’s responsibility for freight and packing charges to and from the service center.
Instructions for lighting and shutting down
the appliance:
1. Read instructions before lighting.
2. Press down the control knob to " LOW ", at the
same time push in the ignition button and keep
the button depressing for 15 seconds.
3. If the burner is not lit in 5 seconds, press down
the control knob and turn clockwise to the
"OFF" position. Repeat from step 2 after 5
minutes.
4. Adjust flame to desired height with the control
knob.
